Deck rope coils are one of the
slight additional details that make the deck of the ship model kits stand out. The following are a few steps that will
help you get the job done right the first time:
Ø Double-sided
tape, scrap wood and brass. Sizes are controlled by what you have in the scrap
boxes.
Ø A
piece of plywood is glued to 25mm dowel, then apply a piece of tape to the
surface of the ply.
Ø Drill
a hole in the base of the scrap timber to a depth of around 20 mm to accompany
the brass sleeve. Load the table top into the sleeve. The top piece will now be
capable of spinning in the completed jig.
Ø Choose
the required gauge and color of rigging cord for the job.
Ø Pull
the cord through the bees wax to obtain maximum control of the cord.
Ø Ready
the tape by taking away the protective coat.
Ø Mark
the center of the top and begin coiling the end of the cord, applying light
pressure that will keep the cord under control.
Ø The
technique is to turn coil and add pressure to the top as you go. It is at this
point that you decide what diameter you require for the job.
Ø Apply
white PVA wood glue and rub in so as to cover the coil.
Ø Drying
time of ship model kits is supposed
to be roughly none hour. Test as you go, or apply heat lights if required.
Ø Once
the coiled rope is dry, do away with the piece with a flat blade ready for
installation.
Ø Make
use of PVA wood glue in order to join the piece and clean up where required.
Capstan Bars & Handspikes
These are essential equipment on
the majority of scale models and if they are loose and not connected to the
windlass or capstan then the holes in the windlass and the capstan to house
these bars are supposed to be square. If the capstan bar is installed in the
capstan, each bar is supposed to be around 1/3 the beam of the ship.
Windlass
A winch, particularly one on a
ship, the windlass is an apparatus for moving heavy weights. Usually, a
windlass consists of a horizontal cylinder supported between cheeks at each
end, it is rotated by the turn of a handspike inserted into the barrel. On a
ship it is usually octagonal in shape to stop slippage, it even generally
consists of a pinion and gear system to gain benefit with heavier loads. As a
result of limited space on a ship, and as one man could merely turn the drum by
a quarter of a turn per pull, the use was discontinued for bigger ships with
heavy loads to shift.
No matter what part of the ship model kits you are working with, always keep in mind that you
need to concentrate on it to ensure it has been joined properly and will not
come out at any time in the future.